SWITNEX 2204 Universal Wireless Remote Control Instruction Manual
SWITNEX 2204 Universal Wireless Remote Control Instruction Manual
| Technical Data | |
|---|---|
| Working voltage | AC 85V~250V |
| Input/output voltage | 1~250V |
| Output Type | Passive output |
| Quiescent Current | <5MA |
| Max current | 10A |
| RF frequency | 433MHz |
| Working temperature | -30~+80 |
| Receiving Sensitivity | >97dbm |
| Amount of storage remote controls | 20 pieces |
| Support encoding | 1527 Leaning code、2262 fixed code |
| RF Operating mode | ASK superheterodyne wireless reception |
| Receiving range | Open space is more than 50 meters |
| Remote operating mode | Momentary Mode / Toggle Mode / Latched Mode |
Product Detail
- NO: Normally open pin
- COM: Common pin
- NC: Normally closed pin
Wiring Diagram
Warning
- Usually the receiver and transmitter have been paired with each other in factory. If not, please reprogram them.
- Reset before you want to change the operating mode.
- After reset, all the remote controls cannot work anymore.
- Replace the battery in time when the remote transmitter voltage is low to get stronger signal transmission.
- Slightly stretch the antenna on the receiver for better signal reception.
- The remote transmitter needs to have 5 or more buttons if you want to set up in latched mode.
- The output type is passive output / potential-free contacts.
Operating Mode
Momentary Mode
Press and hold button “A” → relay “1” turns on
Release button “A” → relay “1” turns off
How to program:
- Press the learning button (on the receiver) 1 time. The indicator LED on the receiver will light up.
- Press button “A” on the remote transmitter. The indicator LED on the receiver will flash several times and then turn off. Succeed.
Toggle Mode
Press button “A” → relay “1” turns on
Press button “A” again → relay “1” turns off
How to program:
- Press the learning button (on the receiver) 2 times. The indicator LED on the receiver will light up.
- Press button “A” on the remote transmitter. The indicator LED on the receiver will flash several times and then turn off. Succeed.
Latched Mode
Press button “A” → relay “1” turns on
Press button “B” → relay “2” turns on, and relay “1” turns off at the same time
How to program:
- Press the learning button (on the receiver) 3 times. The indicator LED on the receiver will light up.
- Press button “A” on the remote transmitter. The indicator LED on the receiver will flash several times and then turn off. Succeed.
Reset
Press the learning button (on the receiver) 8 times. The indicator LED on the receiver will flash several times and then turn off. Succeed.
Troubleshooting
If the receiver and transmitter cannot operate normally, try the following steps:
- Check if battery power is used up. The indicator LED on the remote transmitter does not light up or is dimly lit.
- Check if your receiver is wired correctly. Make sure the wiring is correct.
- Reprogram the receiver and transmitter. Usually this can solve many problems.
- If the problem still remains, please contact us.
Contact
- Email: linktrol@icloud.com
- WhatsApp: +86 15812381273
If there is any question about the products, please contact us first. We will do our best to solve your problem. Thank you.
10% OFF
For an exclusive 10% OFF upgrade discount, Use code: FBA10.
Copy the code before visiting the shop.